![]() The encapsulation ppp configures PPP protocol on the serial interface. Then, configure PPP encapsulation and IP address on Router-B serial 0/0/0 interface. ![]() Router-B beeing the DCE, clock rate has to be configured on Router-B serial 0/0/0 interface Router-B(config)#interface serial 0/0/0 Configure the routers with the following parameters In this example, Router-A is the DTE side, and Router-B the DCE side (DCE V.35, clock rate set). The show controllers command is used to determine which side of the cable is the DCE side. Use the connected laptops to find the DCE and DTE routers ![]() Check IP connectivity between the two routers using the ping command.ġ. Configure the routers with the following parameters :ģ. You can connect to the routers using CLI.Ģ. Use the connected laptops to find the DCE and DTE routers. Practicing this labs will help you to better understand what is a DCE, a DTE, and aclock rates on a serial router interconnection and make you ready for the CCNA ppp labs and simlets.ġ. ![]() This lab will test your ability to configure PPP on a serial link in Packet Tracer 8.0. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |